The S-5-H90 is a one-piece clamp that was developed to securely and cost-effectively accommodate metal roof panels with a horizontal seam greater than 0.65″. Turning the clamp 90 degrees so that the bolt hole side is facing up, slip the clamp on the seam and tighten the setscrews.
S-5-H90 Mini Clamp
The S-5-H90 Mini is a bit shorter than the S-5-H90 and has one setscrew and one threaded bolt hole rather than two. The Mini is the choice for attaching all kinds of rooftop accessories: signs, walkways, satellite dishes, antennas, rooftop lighting, lightning protection systems, solar arrays, exhaust stack bracing, conduit, condensate lines, mechanical equipment—just about anything!*
*S-5!® mini clamps are not compatible with, and should not be used with, S-5! SnoRail™/SnoFence™ or ColorGard® snow retention systems.
No More Mini Bolt – Effective April 1, all S-5! mini clamps will be packaged without M8 bolts. Please check with your distributor for additional information.
Installation is Easy
Turning the clamp 90 degrees so that the bolt hole side is facing up, slip the clamp on the seam and tighten the setscrew. Go to the tools page for information and tools available for properly attaching and tensioning S-5! clamps.
After the clamp is installed, affix ancillary items using either of the two threaded bolt holes and bolt provided. The strength of the S-5-H90 clamp is in its simple design. The setscrews will slightly dimple the metal seam material but will not puncture it—leaving roof manufacturers’ warranties intact.
Please note: The above image illustrates the S-5-H90. The steps remain the same for the S-5-H90 Mini; however, there will only be one setscrew on the clamp.
Load Test Results
Contact your distributor for pricing and ordering.
Product packages in boxes of 50 and cases of 250.
Broken box quantities may incur additional charges.
Setscrews, flanged bolts and a screwgun bit tip are included in each box.