S-5-K Grip™ Clamps

The S-5-K Grip clamp was specifically developed to fit Klip-Rib® and other bulb snap-together seams. The design utilizes multiple inserts (sold separately) in order to accommodate a variety of bulb snap together profiles. Each insert has a unique shape that allows for a tight fit and provides increased holding strength over other attachment options.

S-5-K Grip Mini Clamp

The S-5-K Grip Mini is a bit shorter than the S-5-K Grip and has one base bolt rather than two. The Mini is the choice for attaching all kinds of rooftop accessories: signs, walkways, satellite dishes, antennas, rooftop lighting, lightning protection systems, solar arrays, exhaust stack bracing, conduit, condensate lines, mechanical equipment—just about anything!*

*S-5!® Mini clamps are not compatible with, and should not be used with, S-5! SnoRail™/SnoFence™ or ColorGard® snow retention systems.

No More Mini Bolt – Effective April 1, all S-5! mini clamps will be packaged without M8 bolts. Please check with your distributor for additional information. 

S-5-KGrip Mini

Insert OptionsS5Grip Insert

S-5-GXM 10 Mini Insert
McElroy Metal Mirage
AEP Span Klip-Rib®
Metal Sales Clip-Loc
SpeedDeck® SpeedDeck®
Safintra Saflok 410
Safintra Saflok 700
Domico Dach®
And other similar profiles

S-5-GXM 50 Mini Insert
LYSAGHT KLIP-LOK 700 Hi-Strength®
Stramit® Speed Deck Ultra®
Fielders KingKlip® 700
And other similar profiles

If you have a profile not listed here, please contact S-5! to request a sample for testing.

Installation is Easy

To install the S-5-K Grip Mini, place the clamp insert just under the fold of the rib at the desired location. Next, position the clamp by rolling it over the seam and the clamp insert piece, ensuring it is centered over the clamp insert with approximately 2 mm of insert overhang on each side of the clamp. By hand, partially thread the single flanged bolt into the base of the S-5-K Grip Mini. The bolt should engage in the center of the S-5-K Grip Mini insert. Lastly, tighten the base bolt using a ratchet or screwgun with a 13 mm hex. For optimal holding strength, bolt should be tensioned to 20 inch pounds.


Please note: The above image illustrates the S-5-K Grip. The steps remain the same for the S-5-K Grip Mini, however, there will only be one setscrew on the clamp.

Load Test Results

S-5-K Grip Mini Load Test Results


Contact your distributor for pricing and ordering.

Product packages in boxes of 40 and cases of 200.
Broken box quantities may incur additional charges.

Setscrews, flanged bolts and a screwgun bit tip are included in each box.